[zziggy]

I ended up switching to RCA and everything works like a charm.

[zziggy]

Grr, I’m having no luck.

My current config.txt

# uncomment if you get no picture on HDMI for a default “safe” mode
#hdmi_safe=1

# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1

# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16

# uncomment to force a console size. By default it will be display’s size minus
# overscan.
#framebuffer_width=800
#framebuffer_height=600

# uncomment if hdmi display is not detected and composite is being output
hdmi_force_hotplug=1

# uncomment to force a specific HDMI mode (this will force VGA)
hdmi_group=2
hdmi_mode=4

# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2

# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
config_hdmi_boost=4

# uncomment for composite PAL
#sdtv_mode=2

#uncomment to overclock the arm. 700 MHz is the default.
arm_freq=1000

# for more options see http://elinux.org/RPi_config.txt
core_freq=500
sdram_freq=500
over_voltage=4
gpu_mem=384
avoid_safe_mode=1
force_turbo=0

And my current audio settings on retroarch.cfg

# Enable audio.
audio_enable = true

# Audio output samplerate.
audio_out_rate = 44100

# Audio driver backend. Depending on configuration possible candidates are: alsa, pulse, oss, jack, rsound, roar, openal, sdl, xaudio.
#audio_driver = sdl

# Will sync (block) on audio. Recommended.
#audio_sync = true

Any ideas? I’ve tried flipping just about every option.

[zziggy]

Yeah I tried that but it looks like I didn’t enter the correct resolution.

I ended up fixing the controllers by defaulting the config and remapping the keys again. But now I have no sound! Goodness when does it end! I’ll report back soon, hopefully.

[zziggy]

Fixed this issue by changing the run command in es_systems from 1 to 2. But now I am unable to use my controller in game, but I had the controller working for an entire game of 1943. I’m not sure why it doesn’t work anymore.

[Author]

Posts