[zombiebotking]

Hey thanks for the reply! I’ll try that out and see what happens!

[zombiebotking]

I might have missed that day in class. Would that just be putting “sudo” in front of the commands?

[zombiebotking]

Didn’t work. Same problem. I don’t know where to go from here. Maybe I’ll just use my keyboard if this is going to be such a pain…

[zombiebotking]

Damn! I was hoping it wouldn’t have to come to this.. Well I’ll give it a shot and only install the NES and SNES emulators because it took about 16 hours the first time…

Thanks for the help and I’ll let you know if it works later!

[zombiebotking]

Here’s a more specific picture of the problem.

[zombiebotking]

Hey Karl!

I’m using an official controller but its very old (2006-ish). Don’t know if that matters. Still works fine on my Xbox.

I changed the wid in the rc.local to id and yes, the top right LED lights up fine. It also works to set the ES input.

It just gets to the point where the instructions say to do “sudo cat p*.cfg >> ~/RetroPie/configs/all/retroarch.cfg”.
I am replacing the “*” with a “1” for player one and I’ve tried changing the permissions and have deleted the specified lines but its just not working.

Overall, the controller works fine. It just has problems when I’m setting the config for the emulators, not ES.

Thanks for the help!

[zombiebotking]

Sorry this link didn’t work.
On this page: https://github.com/retropie/RetroPie-Setup/wiki/Setting-up-the-XBox360-controller

[Author]

Posts