[zamuel]

because the USB setup seems to work out of the box, all i had to do was run the retroarch setup once in the menu and it was fine

When I have the PS3 controller connected with USB cable and runs retroarch setup it says that it finds the controller but when going through the buttons it just says timeout and it doesn’t work.

[zamuel]

No one knows why PS3 controllers doesn’t work?
I tried to download the new 2.3 image since I had the 2.2 before but with same result. Everything works fine until I start sixad and it ask for the PS button. Nothing happens and after a while it says “unable to connect to sdp session” and after a while HID error…
I have tried to get this to work in a week now without any success. I first bought a SNES -> USB converter, that doesn’t work and when the PS3 + blutooth dongle that doesn’t work so it get’s a bit frustrating now. Running games with only keyboard is not so fun.

[zamuel]

Shouldn’t it be possible to make a emulator for the n64 that runs at 100%? I remember when the UltraHLE emulator came out for PC. It was possible to run almost all N64 games at 100% speed on my pentium 1 200MHz. Is a Raspberry Pi at 1GHz slower than a 200MHz pentium?

[zamuel]

Yes I have done that. I runned the config for PS3 and I think the Dongle works. When I follow the tutorials, everything seems ok until the last step where I in sixad should press the PS button. Nothing happenes. I do see the LED on the dongle get solid instead of flashing when it isn’t connected and if I run hciconfig it shows the same mac address on both lines which if I understand it correctly says that it is connected, but no controller in Emulationstation.
If I start Emulationstation with the controller connected with a USB cabel it says that it found a controller, but nothing happenes when I press any buttons so it doesn’t work at all.

[Author]

Posts