Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: Two SNES Controllers? #83987
    natedgreat3
    Participant

    It looks like an issue just involving this specific brand of controller. I helped walk another dude having trouble through the exact same steps I did, but he got his working after that.

    I’ve just been playing on one controller, too cheap to get two of another type.

    in reply to: What controllers are you using? #45007
    natedgreat3
    Participant

    Using 2 of these controllers:

    Can get one to work, but not the other (in default RetroArch, in PiSNES they do work). Have tried both registering a retroarch controller and setting them up via retroarch.cfg. Any idea what could be wrong?

    in reply to: Save states not working usb snes controllers #44609
    natedgreat3
    Participant

    Try removing the _btn from both the entries, as per comments in the retroarch.cfg file:

    # Saves state.
    # input_save_state = f2
    # Loads state.
    # input_load_state = f4

    If that doesn’t work still in USBGamepad.cfg, try adding it back into retroarch.cfg as well.. couldn’t hurt at this point =P

    I have not actually tried a Save/Load state on my end yet.. still hung up over this 2 player issue heh. I’ll try tomorrow and see whether mine works.

    in reply to: Save states not working usb snes controllers #44588
    natedgreat3
    Participant

    And you are holding down “Select” while pressing on the Right bumper to save… holding down “Select” while pressing on the Left bumper to load, correct?

    in reply to: Save states not working usb snes controllers #44568
    natedgreat3
    Participant

    Okay… so I think that actually dumps the button mappings into /home/pi/RetroPie/emulators/RetroArch/configs/USBGamepad.cfg

    Append your savestate mappings to that file and maybe it’ll work.

    Can you also post what your file looks like with 2 controllers? I’m having my own issues… 1 SNES controller works but the other doesn’t… but I followed ZSprawl’s 2.3 setup guide which did not mention registering a controller that way. Maybe we can both help each other out =]

    in reply to: Save states not working usb snes controllers #44562
    natedgreat3
    Participant

    How did you set up your controllers? I don’t see any controller button mappings defined in your config file. If they’re defined somewhere else, you would probably need to copy your save state mappings over there.

Viewing 6 posts - 1 through 6 (of 6 total)