Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • in reply to: emulator or game specific configuration files #86217
    mytheral
    Participant

    Ahh Haa!! thank you all for your help. I was able to FTP into my config directory again and created the cfg folder sncboom2k said to make and it worked perfectly after that! My buttons are staying to what I configure them as in the GUI. Thank you all again for your help!!

    I think I only have one more problem to post about (not related to input configuration) and this project of mine should be good to go!

    in reply to: emulator or game specific configuration files #86186
    mytheral
    Participant

    another screen shot

    in reply to: emulator or game specific configuration files #86183
    mytheral
    Participant

    Ok i was able to FTP and delete the corresponding config folders for mame and mam4all… both times it did not work. below are the screenshots and it includes my path to make sure I am in the right place.

    When i deleted the folder, i did not add the contents that were in that folder into the new folder I created. was this correct?

    in reply to: emulator or game specific configuration files #86141
    mytheral
    Participant

    Hmm I will have to try that. I haven’t used ftp with my pi but I’m sure it’s easy enough with my pi ip. I’ll let you know the results. Hopefully I can get to it tomorrow. Thank you!

    in reply to: emulator or game specific configuration files #86132
    mytheral
    Participant

    I have somewhat of a similar problem.

    I am using a wired XBOX 360 controller and I use the GUI to change the inputs as shown in the video and the changes work just fine during the game but when I escape the game and go back to Emulationstation and start a new game, the configuration is set back to default without my inputs I have just setup.

    Anything I am missing?

    in reply to: Best Two Player Joystick Kit #86076
    mytheral
    Participant

    I have also been thinking about getting the X-Arcade 2 player controller just for it’s ease of use with Emulation Station. It has all of the mapping built in. I do have a question though…

    How does the X-arcade handle the console controls? (NES, SNES, SEGA)

    Since it’s basically an emulated keyboard, I wouldn’t see any problems handling it but I figured I would ask and see if anyone has had any experience with it.

    Thanks!!

Viewing 6 posts - 1 through 6 (of 6 total)