[gilera]

I had a similar issue with some games not showing up – it turned out to be because something had happened during the copy process and the files were 0KB.

Just check a few of the files and make sure the sizes match. I doubt it’s that due to how many files you’re talking about but worth a check all the same.

[gilera]

I haven’t implemented the fix but I have the same issue with regards to it wanting to configure my ps3 pad every time on boot.

I get around this by turning the ps3 pad off then back on again – bit of a pain but i’m happy until i get everything else working as i want then i’ll fix that :)

[gilera]

What did you start with as your base install? Raspbian?

The build must be failing further up, can you see anything if you scroll up? If not you can always run the build with logging and review the log afterwards.

[gilera]

I don’t want to hijack the thread but i do have the same issue, all other emulators seem to work OK (including mame-libretro) but mame (mame4all) doesn’t.

I notice in the emulationstation es_systems.cfg file that mame4all gets started without specifying the retroarch.cfg file.

In the same file mame-libretro is started with the retroarch.cfg and my pad works as expected but i have other issues with mame-libretro so would like to use mame4all.

I’ve tried using the keyboard, TAB, ESC etc but nothing works, i started the mame4all emulator from cli without loading a rom and controls don’t work on the front-end menu and neither does the keyboard.

Any ideas?

PS. Oh and thanks for this amazing setup-script I’ve had so much fun these past few days.

[Author]

Posts