Homepage Forums RetroPie Project Peoples Projects Work in progress! Xbox 360 arcade box

Tagged: , ,

Viewing 1 post (of 1 total)
  • Author
    Posts
  • #102573
    fistfull95
    Participant

    Hey everyone,

    I got introduced to the RPi2 at my work, and have been addicted ever since. I have wanted to RGH an Xbox 360 console for a long time, but with 5 failed attempts and thus now bricked or molten consoles I decided to take a different approach.

    I have decided to use just the case of an Xbox 360 (Phat) console, and strip just about all hardware.

    I will be running a RPi2 with RetroPie installed, and games will be played with an Xbox 360 controller.

    If you have any suggestions or comments, please leave a reply!

    [7-22-15 | Initial start up of project]

    Not everything has arrived (including the RPi2 lol), so I will start modding the case first. I have decided to fill the vent holes on the back of the case. I found some quickplaster lying around in my house, but I am quite sure that this is not the right plaster to be used. I have tried it anyway, and here are a few pictures. Now these pictures were taken when the plaster was still wet to the touch, so I’ll have to sand it down when it is dry.

    [img]http://i.imgur.com/2Mm3J9x.jpg[/img]
    [img]http://i.imgur.com/h1dZyjOl.jpg[/img]
    [img]http://i.imgur.com/FLemJwsl.jpg[/img]

Viewing 1 post (of 1 total)
  • The forum ‘Peoples Projects’ is closed to new topics and replies.