Homepage › Forums › RetroPie Project › Peoples Projects › My Portable Project

Tagged: 

Viewing 11 posts - 1 through 11 (of 11 total)
  • Author
    Posts
  • 11/30/2015 at 16:33 #110946
    steven02
    Participant

    HI, i am very happy to present my project

    Spec:

    Raspberry PI 2 900MHz 1Gb Ram,
    LCD 4.3″ 480×272 connected by Composite cable with harware backlight adjustement,
    Stereo speaker with Amplificator and Volume adjustement,
    12 button + Directional cross connect on GPIO as Keybord(More info),
    USB redirecting to Bottom of shell,
    RJ45 and Composite Output on multiport on Bottom of shell,
    HDMI and audio Jack on Top of shell,
    ALL LED are redirecting on RGB LED on top of shell

    NOW THE PICTURE

    Face

    Back

    Bottom

    Up

    Interior

    11/30/2015 at 22:43 #110963
    redhalo
    Participant

    That is insane. How did you make the enclosure, 3d printed?

    12/01/2015 at 16:38 #111016
    steven02
    Participant

    Yes all plastics(enclosure and all button without volume and backlight controle) is make with 3d printer.

    12/02/2015 at 11:29 #111060
    mat jessop
    Participant

    I second Redhalo’s comment. This is a seriously impressive and comprehensive build! Definitely one of the best I have seen.

    01/21/2016 at 11:41 #114615
    xtremekick
    Participant

    Hi!

    For 12 button + Directional cross, you cut a PCB of a controlpad?, or you buy this two PCB circuit with buttons?

    i need a pcb with cross control and buttons… without cutting controlpad (i want make much portables, no only one, need save time of cutting, etc).

    01/21/2016 at 12:24 #114616
    steven02
    Participant

    Hi’

    I use Prototype PCB Universal Experiment Circuit Board and tact switch with this you can place your boutton where you want.

    PCB circuit board
    Pcb
    Tact switch
    Switch

    01/21/2016 at 16:58 #114646
    labelwhore
    Participant

    Excellent work! I tried to do a handheld, but failed miserably. lol I’m still not all that great with my 3D printer.

    01/21/2016 at 22:29 #114690
    steven02
    Participant

    I have not merit, i’am a industrial engineer in france.

    01/22/2016 at 02:56 #114708
    InsecureSpike
    Participant

    this is sweet!
    great work!!

    01/28/2016 at 13:50 #115433
    smartroad
    Participant

    Awesome design!

    02/05/2016 at 02:12 #116263
    ShadowKnight
    Participant

    This made my day ^_^ My original design was similar to this but my skills weren’t… With a bit of acetone and a painters brush to apply, it would look glossy and factory made!

    Keep up the beautiful work, you’ve just inspired me to make a new one =D

  • Author
    Posts
Viewing 11 posts - 1 through 11 (of 11 total)
  • The forum ‘Peoples Projects’ is closed to new topics and replies.