Hi,
Just got my lovely control block assembled and wired up to original SNES controller board and have just re-installed all the binaries again from retropie setup screen.
I am a bit of a noob when it comes to issuing commands on the back end; on the main site is says I must setup the control block service (or driver?) before it will work. How do I do this, I have no idea how to edit cfg files etc.
**ALso on a side note, My rocker switch turns the Pi on (which is good)but then it does nothing after this despit switching it back.forth and the led is always glowing slowly?
Thanks in advance for your help
.
.