Homepage › Forums › RetroPie Project › Everything else related to the RetroPie Project › xbox wireless reciever question

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • 02/10/2014 at 20:48 #4812
    wrichards
    Participant

    ive been battleling the dual ps3 wireless controllers all weekend and not quite cracked it… I want to try the wireless xbox 360’s but have a question on the receiver part. im assuming this – http://www.amazon.com/gp/product/B000HZFCT2/ref=ox_sc_act_title_1?ie=UTF8&psc=1&smid=A1PBXAJUCQQZJO

    will be fine for the pie?

    thanks in advance for any/all responses :)

    02/11/2014 at 12:39 #4825
    retrofredde
    Participant

    I’m using this one, which seems very similar
    http://www.ebay.com/itm/360368437761

    I didn’t get it to work on my PC but it works flawlessly on RetroPie, I have the pi powered on all the time, when pushing the 360 guide button the controller powers on and connects to the receiver within 3-5 seconds and then after putting the controller down it powers off after 15 minutes or so.

    02/11/2014 at 20:08 #4836
    wrichards
    Participant

    nice thanks.. I figure its the easiest way to use a wireless without the hard connect pairing.. thanks again

    02/16/2014 at 20:38 #4967
    wrichards
    Participant

    Update… the adapter receiver worked flawlessly, had a rough bit but turned out to be a failing sd card… other that that, the guids in this forum were stop on. Thanks to everyone for helping make this little wonder. Interestingly enough, the ps3 setup seems a tad slower than the 360 setup… jusy fyi and thanks… I found alotta errors or such on older posts, I figure ther do to older versions, but all in all everything you need to set up ps3s or 360s in in these forums….. THANKS EVERYONE

  • Author
    Posts
Viewing 4 posts - 1 through 4 (of 4 total)
  • The forum ‘Everything else related to the RetroPie Project’ is closed to new topics and replies.