I’ve a problem with the GPIO Adapter: The SNES Controller is only working in EmulationStation. I can start the Initial Setup in ES and configure the controller, but when I try to save this Initial Setup, I get a Script error.

I did the following steps:

1. Used a fresh SD-Card Image
2. Installed SNESDev driver and library viao Setup-Script
3. Enabled SNESDev on boot
4. Removed ES input config
5. reboot

Now, ES Starts and I can configure the SNES gamepad for the ES Menu.
When I then try to configure the controller via Setup-Script with the command line tool, I get only time outs, the controller is not responding in the command line tool.
Neither in the joystick_configuration tool, nor in the testButton tool from SNESDev.

Thanks for your support in advance!