Homepage › Forums › RetroPie Project › New to RetroPie? Start Here! › FBA retroarch GUI not saving settings

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • 04/05/2016 at 21:27 #122464
    cyborguk
    Participant

    Hello,

    I’ve just installed a fresh copy of 3.6 and ran the binary updates and configured my controls on startup. I have just add Street Fighter 2 to FBA and configured the proper controls (light, medium, strong punch and kick buttons) and save the configuration, but when I exit the game and start it again the controls go back to the defaults.

    I’ve also manually tried to configure the file at /opt/retropie/configs/fba/retroarch.cfg and still it doesn’t save the controls and reverts back.

    Am I doing something wrong?

    Thanks

    04/05/2016 at 21:31 #122465
    herbfargus
    Member

    did you enable save settings on exit? your best bet is to set your configs manually

    https://github.com/retropie/retropie-setup/wiki/RetroArch-Configuration

    04/05/2016 at 21:44 #122466
    cyborguk
    Participant

    Yeah I’ve set that option too. Is there a specific way to exit the game to save it?

    I’ve manually set the config, but the GUI shows the usual old settings.

    This is something I’ve not had issues with before.

    I usually configure /opt/retropie/configs/fba/retroarch.cfg should I be using /opt/retropie/configs/all/retroarch.cfg ?

    Thanks

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • The forum ‘New to RetroPie? Start Here!’ is closed to new topics and replies.